4 Replacement Procedures 4.17 Front panel
4.17 Front panel
Removing the Front panel
To remove the front panel, follow the steps below and refer to Figure 4-27.
1. Disconnect the LED cable to the connector CN9510 on the LED board.
2. Peel the glass tape.
3. Disconnect the speaker cable to the connector CN6350 on the system board.
4. Disconnect the microphone cable to the connector CN6050 on the system board.
5. Lift up the front panel and remove the front panel.
Front panel
CN9510
CN6350
CN6050
Glass tape
LED cable
Speaker cable
Microphone cable
Figure 4-27 Removing the Front panel
Installing the Front panel
To install the front panel, follow the steps below and refer to Figure 4-27.
1. Install the front panel to the base assembly.
2. Connect the microphone cable to the connector CN6050 on the system board.
3. Connect the speaker cable to the connector CN6350 on the system board.
4. Use the glass tape to affix the speaker cable to the base assembly while pulling, so
that the speaker cables does not come loose.).
5. Connect the LED cable to the connector CN9510 on the LED board.
4-36 [CONFIDENTIAL] PORTÉGÉ R300 Maintenance Manual (960-591)
To Next Page
Loading...
