4.12 LCD unit 4 Replacement Procedures
Harness holder
Hinge (L)
Hinges cover (R)
M2×4C S-THIN HEAD
LCD unit
Hinges cover (L)
Hinge (R)
M2.5×5BS FLAT HEAD
M2×4C S-THIN HEAD
M2.5×5BS FLAT HEAD
Figure 4-18 Removing the LCD unit
Installing the LCD unit
Install the LCD unit, follow the steps below and refer to Figure 4-18.
1. Set the hinge cover (L/R) to the LCD unit and secure it with the following screws.
• M2×4C S-THIN HEAD screw ×2
2. Install the LCD unit to the base assembly and secure it with the following screws.
• M2.5×5BS FLAT HEAD screw ×2
3. Install the harness holder.
Removing the LCD panel
To remove the LCD panel, follow the steps below and refer to Figure 4-19.
1. Remove the mask rubbers (2 points) and following screws securing the LCD mask.
• M2×4C S-THIN HEAD screw ×2
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-27
To Next Page
Loading...
