4.15 HDD 4 Replacement Procedures
4 Replacement Procedures
4.15 HDD
CAUTION: When handling the HDD, do not press the top surface as shown by the arrow.
Hold it by the sides.
Removing the HDD (only 1.8” HDD model)
To remove the HDD, follow the steps below and refer to Figure 4-22 and Figure 4-23.
1. Disconnect the HDD cable from the connector CN1800 on the system board.
HDD cable
CN1800
Figure 4-22 Removing the HDD (only 1.8” HDD model) (1)
2. Lift up the HDD.
3. Disconnect the HDD cable from the HDD.
4. Remove the HDD cap from the HDD.
HDD
HDD cable
HDD cap
Figure 4-23 Removing the HDD (only 1.8” HDD model) (2)
PORTÉGÉ R300 Maintenance Manual (960-591) [CONFIDENTIAL] 4-31
To Next Page
Loading...
