6F3B0250
Basic Hardware and Function
37
1. System Configuration
1.9 Peripheral tools
The following peripheral tools are available for the T1/T1S.
T-Series Program Development System (T-PDS)
The T-Series Program Development System (T-PDS) is a software which runs on any
IBM-PC compatible personal computers such as Toshiba’s Notebook computers. The
same T-PDS software supports on-line/off-line programming, debugging and program
documentation for all the T-Series programmable controllers T1/T1S, T2/T2E/T2N and
T3/T3H.
·
User-friendly program editor includes cut & paste, address search & replace,
program block move/copy, etc.
·
Group programming
-
part program development by multiple designers and
merging them into a complete program
-
enhance the software productivity.
·
Powerful monitoring, I/O force and data set functions fully support your program
debugging.
·
Documentation of programs with commentary makes your maintenance work easy.
·
Remote monitoring/programming via modem (radio/phone) is possible.
The table below shows the T-PDS versions that support the T1/T1S.
Type Part number Versions available for
T1 T1S
T-PDS for Windows TMW33E1SS Ver 1.0 or later
*1)
Ver 1.2 or later
T-PDS for MS-DOS TMM33I1SS Ver 1.61 or later
*1)
Ver 2.1 or later
*1) The T1S can be used with these versions. However, in this case, there are the
following functional limitations.
·
The program size setting is only available as 2 k. It is set to 4 k mode in the T1S.
·
Some of the added instructions (MAVE, DFL, HTOA, ATOH) may not be
edited/monitored. (depending on the version)
NOTE
The connection cable for the T1 Series is different from that for upper T-Series
PLCs. These cables are supplied separately.
Connection cable for T1/T1S ... Type: CJ105, 5 m length
Connection cable for T2/T3
¼
. Type: CJ905, 5 m length
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
