6F3B0250
48
T1/T1S User’s Manual
2. Specifications
2.4 I/O specifications
2.4.1 T1-16
·
··
·
T1-16 input specifications
Item Specifications
DC input type AC input type
AC power type DC power type
Input type Dry contact input,
current source or
sink
DC input,
current source or
sink
AC input
Number of input
points
8 points (8 points/common) 8 points (8 points/common)
Rated input volta
e Supplied from
T1-16
(24 Vdc,
±
10 %)
24 Vdc,
+10/-15%
100 - 120 Vac, +10/-15 %,
50/60 Hz
Rated input current 7 mA (at 24 Vdc) 7 mA (at 100 Vac)
ON level Contact close
(max. 1.2 k
W
)
Min. ON
volta
e: 15 Vdc
Min. ON volta
e: 80 Vac
OFF level Contact open
(min. 20 k
W
)
Min. OFF
volta
e: 5 Vdc
Max. OFF volta
e: 30 Vac
ON delay time 0 to 15 ms
25 ms or less + user settin
OFF delay time 0 to 15 ms
30 ms or less + user settin
Input si
nal display LED display for all points, lit at ON, internal lo
ic side
External connection Terminal block (fixed), M3.5
Withstand volta
e 1500 Vac, 1 minute (between internal and external circuits)
Internal circuit
*1: The input current direction (source or sink) of the dry contact input can be selected by the
internal jumper plug. (Factory setting = current source) Refer to section 3.1.
3 side: current flows from input terminal to (
-
) terminal (current source)
1 side: current flows from (+) terminal to input terminal (current sink)
*2: The jumper plug of the DC power supply type must be set to 1 side.
*3: The input ON/OFF delay time of the DC input type can be changed by user. The setting range is
0 to 15 ms. (Default value = 10 ms) Refer to section 8.2.
*4: The input ON/OFF delay time of the AC input can be extended by user. The extension setting
range is 0 to 15 ms. (Default value = 10 ms) Resulting the default delay times are 35 ms (ON
delay) and 40 ms (OFF delay). Refer to section 8.2.
LED
+
-
24 Vdc
(AC power type only)
,
13
7
0
LED
C
7
0
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
