6F3B0250
Basic Hardware and Function
77
4. Installation and Wiring
In case of the expansion rack is connected to the T1/T1S, the rack mounting screw is
used for this purpose.
·
1.25 mm
2
(16 AWG) wire should be used to connect the T1/T1S and the expansion
rack/unit with the enclosure grounding bus bar.
·
100
W
or less to ground is required.
System ground
T1
Expansion rack
Mounting panel
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
