90 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Input Terminal 10 (LI2) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI2 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI2 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Direct Access Number —
F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 11 (LI3) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI3 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI3 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Direct Access Number —
F121
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 12 (LI4) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI4 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI4 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 1 option board (P/N
ETB003Z) is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N
58685) for additional information on the function of this terminal.
Direct Access Number —
F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F120 – F123
To Next Page
Loading...
