Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 91
Input Terminal 13 (LI5) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI5 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI5 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F123
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 14 (LI6) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI6 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI6 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F124
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 15 (LI7) Function
Program Terminal Input Terminals
This parameter is used to set the functionality of the LI7 discrete
input terminal.
In addition, this input terminal must be specified as Normally
Open or Normally Closed.
This setting assigns the function of the programmable LI7 termi-
nal to one of the user-selectable functions listed in Table 9 on
page 252.
Note: The Expansion IO Card Option 2 option board (P/N
ETB004Z) is required to use this terminal.
See the Expansion IO Card Option 2 instruction manual (P/N
58686) for additional information on the function of this terminal.
Direct Access Number —
F125
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F123 – F126
To Next Page
Loading...
