Toshiba Q9+ - Page 146

134 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Preset Speed 11
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1011 and is identified as Preset Speed 11. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F290
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 12
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1100 and is identified as Preset Speed 12. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F291
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 13
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1101 and is identified as Preset Speed 13. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F292
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
Preset Speed 14
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number
1110 and is identified as Preset Speed 14. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
See F018 for additional information on this parameter.
Direct Access Number —
F293
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower-Limit Freq.
(F013)
Maximum — Upper-Limit Freq.
(F012)
Units — Hz
F290 – F294