226 https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
Communication 2 Time-Out Condition
Program Communications Communication Options
This parameter determines the condition under which the drive
will detect time-out errors.
Settings:
0 — Always Detect
1 — Detect Time-Out Error During Communications
2 — Detect Time-Out Error During Communications and
Running
Direct Access Number —
F849
Parameter Type — Selection List
Factory Default — Always Detect
Changeable During Run — Yes
Disconnection Detection Extended Time
Program Communications Communication Options
This parameter is used to set the length of time that no communi-
cations activity may exist before the communications link is dis-
connected.
Direct Access Number —
F850
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — 100.0
Units — Seconds
ASD Operation at Disconnect
Program Communications Communication Options
This parameter is used to set the Q9 Plus ASD action to be car-
ried out in the event of the loss of communications.
Settings:
0 — Stop and Terminate Communication
1 — Do Nothing (Continue Programmed Operation)
2 — Deceleration Stop
3 — Coast Stop
4 — Emergency Off
5 — Preset Speed (Setting of F852)
Direct Access Number —
F851
Parameter Type — Selection List
Factory Default — Stop and Ter-
minate Communication
Changeable During Run — Yes
Preset Speed Operation
Program Communications Communication Options
This parameter setting is used to set the Preset Speed selection
to be used if Preset Speed is selected at parameter F851.
Settings:
0 — Disabled
1–15 — Preset Speed Number
Direct Access Number —
F852
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F849 – F853
To Next Page
Loading...
