Toshiba Q9+ - Page 237

Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
https://www.toshiba.com/tic/ 225
Communication Option (DeviceNet/Profibus) Setting10
Program Communications Communication Options
While using the DeviceNet/Profibus communications protocol,
parameters F841 – F848 allow the user to select the ASD mem-
ory location that holds the Command/Frequency/Monitoring
instructions to be applied to the ASD for Communications Option
Settings 10 – 17, respectively.
See the DeviceNet Option Instruction Manual (P/N 58683) for
additional information on this parameter.
Direct Access Number —
F841
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 11
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F842
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 12
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F843
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 13
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F844
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 14
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F845
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 15
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F846
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 16
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F847
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
Communication Option (DeviceNet/Profibus) Setting 17
Program Communications Communication Options
See F841 for information on this parameter.
Direct Access Number —
F848
Parameter Type — Selection List
Factory Default — 0000h
Changeable During Run — Yes
F841 – F849