Startup Wizard
Q9 Plus ASD Install/Op Manual
32 https://www.toshiba.com/tic/
Settings:
1 — V/I
2 — RR
3 — RX
5 — EOI Keypad
6 — RS485/BACnet
7 — Communication Option Board
8 — RX2 (AI1 Option)
9 — Option V/I (AI2 Option)
10 — UP/DOWN Frequency
11 — Optional RP Pulse Input
12 — Optional High-Speed Pulse Input
10. Display Units
(F701)
This screen sets the display units for current and
voltage.
Settings:
0 — %
1 — A/V (Amp/Volt)
11. Wizard Finished!
This screen is the final screen of the Startup
Wizard. The basic parameters of the Q9 Plus ASD
have been set. Click Exit to load the Startup Wizard
input and to return to the Frequency Command
screen. Additional application-specific programming
may be required.
Exit
To Next Page
Loading...
