User’s Manual 8-14
AV functions
Replacing the batteries
When the batteries in the Full size remote controller reach the end of their
life, the Full size remote controller may not operate correctly or work only
within a short distance from your computer. In this instance, you should
purchase new batteries and replace the discharged ones.
1. Open the battery cover on the back of the Full size remote controller.
2. Replace the batteries.
Be sure to place the batteries with their polarities (+ and -) in the correct
position.
Figure 8-9 Removing the batteries
3. Close the battery cover.
Close the cover securely until it clicks.
Slim size remote controller
Installing the battery
1. Open the battery cover on the back side of the remote controller.
Figure 8-10 Opening the battery cover
2. Be sure to place the battery with correct polarities. Press the battery
down to the stopper then push it forward to fit into the battery case.
Figure 8-11 Inserting the battery
Batteries
Battery cover
Stopper
Battery
To Next Page
Loading...
Need help?
General