Automatic restart after power failure
Press the “ “ button to
display the “Menu screen”
9) Press and hold the “ “ button
and the “ “button at the same time
for more than 4 seconds to display the
“Field setting menu”
10) Scroll down to item “5” using the
button.
11) Press “F2” Code (DN) 10
will be highlighted on the left of the display.
12) Scroll the Code (DN) to 28 using the
“ “buttons.
13) When Code (DN) 32 is highlighted on the left
press “ [F2]” to highlight “Data”
on the right.
14) Change “Data” from “0000” to “0001” by
pressing the “ “
15) Press “ “follow on screen instructions.
To Next Page
Loading...
