4.17 Fingerprint Module 4 Replacement Procedures
3. Remove the Fingerprint module by lifting it gently.
Figure 4-51 Removing the fingerprint module
Installing the Fingerprint Module
To install the Fingerprint Module, follow the steps below and refer to the figures in the
preceding section:
1. Turn the top cover upside down and place the Fingerprint Module and the Fingerprint
Module Bracket in position on top.
2. Secure the Fingerprint Module bracket with four M2.5x3 screws.
Satellite P200D/P205D Series Maintenance Manual
[CONFIDENTIAL]
4-45
To Next Page
Loading...
