4 Replacement Procedures 4.14 Bluetooth
4.14 Bluetooth
Removing the Bluetooth module
To remove the Bluetooth module, first remove the keyboard and the strip cover as described
in the preceding section and then follow the steps below:
1. Disconnect the Bluetooth cable (JP12) from the Bluetooth module.
Figure 4-40 Disconnecting the Bluetooth cable
2. Slide out the Bluetooth module in direction of the arrow.
Figure 4-41 Removing the Bluetooth module
Installing the Bluetooth module
To install the Bluetooth module, follow the steps below and refer to the figures in the
preceding section.
1. Seat the Bluetooth module on the top chassis in place.
2. Connect the Bluetooth cable (JP12) to the module.
4-38
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual
To Next Page
Loading...
