4 Replacement Procedures 4.21 VGA PCB
3. Gently pull it out away from the CRT port and lift it out from the chassis.
Figure 4-63 Removing the CRT PCB
Installing the CRT PCB
To install the CRT PCB, follow the steps below and refer to the figures in the preceding
section.
1. Seat the CRT PCB in the chassis.
2. Replace the M2x6 screw to secure the CRT PCB.
3. Replace the two hexagonal screws to secure the CRT port.
4. Connect the CRT PCB FFC cable to its socket on the system board.
4-54
[CONFIDENTIAL]
Satellite P200D/P205D Series Maintenance Manual
To Next Page
Loading...
