CIX40 Installation
Installing the CIX40 Cabinet
1-22 Strata CIX40 Installation & Maintenance 5/06
Step 4: Install the GIPH1 8-Channel IP Interface PCB (optional)
1. In the CIX40 cabinet, remove the two screws and the PCB stopper (Figure 1-17).
2. Turn off system power. If the GCTU2 is installed remove it before installing the GIPH1.
3. Install the GIPH1 into the GMAS (sub-motherboard) (see Figure 1-12 and Figure 1-17).
4. Install the GCTU2.
5. Replace the PCB stopper and secure with the oridginal two screws.
6. Turn system power ON.
Note To program GIPH1, refer to the Strata CIX Programming Manual Vol. 1 and use eManager.
Licenses are required for IP Telephone and Strata Net IP. Use eManager R4.12A05, or later, to
apply the necessary licenses to the GCTU2 for GIPH1 operations.
Figure 1-16 GIPH1 Card
Reset switch
Serial port
HB LED
Channel 8
Channel 7
Channel 6
Channel 5
Channel 4
Channel 3
Channel 2
Channel 1
LAN Port
To Next Page
Loading...
