Toshiba Strata CIX40 - PCB Installation

CIX40 Installation
Installing the CIX40 Cabinet
1-14 Strata CIX40 Installation & Maintenance 5/06
PCB Installation
Overview Instructions
The following is an overview for installing the Printed Circuit Boards (PCBs) into the Strata CIX40.
After reading this section, proceed to the step-by-step instructions for each PCB.
1. Apply proper settings on the GMAU2 (motherboard Figure 1-14).
2. If applicable, set SW6 battery jumper to ON and install the GVPH1 Voice Mail card
(Figures 1-15).
3. Set P601 battery jumper to ON and install the GCTU2 (processor and Figure 1-18 on Page 1-
24).
4. If applicable, install the GCDU2 (3 CO, 3 CLID and 8 DKT circuits Figure 1-19).
5. If applicable, install GSTU1 (standard telephone interface Figure 1-20).
6. If applicable, install the BSIS for SMDR (Figure 1-18).
7. If applicable, install HPFB-6 battery/charger (Figure 1-23).
8. Connect wiring (Table 1-15).
9. Connect AC Adaptor to P2 of the CIX40 sub-motherboard (GMAS, Figures 1-24) and plug the
AC Adaptor into AC power.
10. Turn the System ON by sliding the SW1 ON/OFF switch down. The ON/OFF LED located by
the GMAU2 label, STANDBY will light (Figure 1-14).
PCB Descriptions
This describes the CIX40 cabinet PCBs (see Table 1-4 and Figure 1-12.)
Table 1-4 CIX40 (CHSU40) Cabinet circuit cards
Part Title Description
GMAU2 Main Motherboard The GMAU2 motherboard supports 3 CO lines, 3
CLIDs, 8 Digital Telephones, 1 Standard Telephone.
The GCTU2, GVPH1, GIPH1, and AC power adaptor
plug into the GMAS2 sub-motherboard dedicated slots.
GMAS2 Sub-motherboard
GCTU2
Processor
(with built-in modem/NIC)
Shipped in a separate box.
GVPH1 Voice Mail Circuit Card (Optional) Voice Mail.
GCDU2 CO, CLID, DKT circuit card
(Optional) Supports 3 CO lines, 3 CLIDs, 8 Digital
Telephones. The GCDU2 plugs onto the motherboard.
GSTU1 Standard Telephone Circuit Card (Optional) Provides 1 Standard Telephone port.
GIPH1 8 Channel IP Interface Card (Optional) 8-Channel IP Interface with LAN-NIC
BSIS RS232C (Optional) RS232-C. Provides 4 serial I/O ports.
HPFB6 External Battery (Optional) Provides backup Reserve power.