CIX40 Installation
CIX40 Installation
Installing the CIX40 Cabinet
Strata CIX40 Installation & Maintenance 5/06 1-13
3. Place the cabinet base on the desired
location on the mounting surface and
mark the location of the four screw
holes. See Figures 1-10 and 1-11.
4. Using a hard board between the
cabinet and the wall, secure the hard
board to the wall first, making certain
that screws are aligned with studs. See
Figure 1-11.
5. Drill holes on these marks and secure
screws approximately two thirds of the
way into the top two holes on the
mounting surface.
6. Hang the unit from the top two screws
and then secure the top screws
completely into the mounting surface.
7. Finish securing the unit to the mounting
surface by completely screwing the
bottom two screws into the wall.
Figure 1-11 CIX40 Cabinet Wall Mounting
8. Ground system according to “AC Power and Grounding Requirements” on page 1-10.
7104
Figure 1-10 CIX40 Interior
Mark screw
locations.
Method 2
Stud
Plaster
Board
Hard Board
(1/2 Inch Plywood)
Base KSU
7114
To Next Page
Loading...
