CIX40 Installation
CIX40 Installation
Telephone Compatibility
Strata CIX40 Installation & Maintenance 5/06 1-3
CIX40 System Licenses
The analog CO lines, digital telephones, standard telephones, voice mail ports, DTMF circuits,
attendant consoles, ACD VA ports and BSIS serial ports do not require a license for operation on
the CIX40. IP Ports on the optional GIPH1 card require licensing on the GCTU2A processor as
follows:
• Each Toshiba IPT2000 series telephone and SIP Telephone requires one LIC-CIX-IP_Port
license.
• Each Strata Net IP channel requires a LIC-CIX-STRN-CH license.
• Toshiba SoftIPTs require a LIC-SOFTIPT license and one LIC-CIX-IP_Port license for each
SoftIPT.
Telephone Compatibility
The Strata CIX40 supports all current Toshiba 2000-series, 3000-series and 3200-series digital
telephones, IP telephones, Add-on Modules, DSS Consoles, and CIX Attendant Consoles.
Generic single-line telephones (2500-sets) are compatible. The Strata CIX40 does not support
analog electronic telephones (6500-series, 6000-series, etc.).
DKT stations connected to the CIX40 support Handset Off-hook Call Announce (OCA) but not
Speaker OCA.
IPT stations connected to the CIX40 support both Handset Off-hook Call Announce (OCA) and
Speaker OCA.
Note IPTs do not require BVSU to receive Speaker OCA (S-OCA) but do require an additional IP
channel on the GIPH IP interface card. If an IPT is enabled to receive S-OCA a second IP
channel will be reserved automatically for this IPT - if there are no available IP channel
when enabling S-OCA, eManager will receive an error message. Only one IP End Point
license is required for an IPT to receive speaker OCA even though two IP channels are
needed. Use PROG 204-06 – To select Speaker OCA as the type of OCA to receive. Use
PROG 103-38 – To enable a COS to receive OCA. Use PROG 200-04 – To put the
telephone in a COS that is enabled to receive OCA.
Toshiba IP Telephones, Soft IPT and SIP phones are supported by the CIX40.
.
To Next Page
Loading...
