CIX40 Installation
CIX40 Installation
Installing the CIX40 Cabinet
Strata CIX40 Installation & Maintenance 5/06 1-21
Remote Connection
Remote communication to the GVPH1 requires the installation of a modem on the UADM PC (if a
modem does not already exist). The GVPH1 comes equipped with an internal modem (AMDS
daughter board) of 33.6 Kbps baud and does not require any additional equipment.
UADM PC Modem
Prepare the UADM PC by installing, connecting and configuring a modem. The modem
must be capable of communicating at a minimum of 9600 baud.
CAUTION! Internal modems configured for COM ports 3 or 4 are not supported by
UADM software.
The UADM PC’s modem connects to the GVPH1 through User ID 993.
Table 1-9 LED Indicators on the GVPH1
Indication/ State
GVPH1 LEDs
Ch1 Ch2 Ch3 Ch4 Status
Power On
(Initialize Sequence*)
All LEDs turn ON (Red), then all LEDs turn OFF and cycle ON/OFF through
all ports for one to two minutes while initializing and then all LEDs turn off.
Normal
(Busy/Idle)
OFF OFF OFF OFF
Blinking
ON = Busy; OFF = Idle
Failure Blinking Blinking Blinking Blinking OFF
Shut Down ON ON ON ON OFF
Back Up/Restore ON ON ON ON ON
No 1.8V input Voltage
in GVPH1
ON OFF OFF ON ON
Not mounted/
defective
Light flickers and switches from the LED to LED (from Ch1~Ch4) + Status
LED
* The initialize sequence operates each time the CIX40 power is cycled off/on or the CIX40
processor is reset or initialized – GVPH1 program data remains saved. However, if the GVPH1
battery jumper is removed, GVPH1 program data and saved messages will be erased.
To Next Page
Loading...
