CIX40 IP Telephony
Install IP Telephones
Strata CIX40 Installation and Maintenance 7/06 2-3
CIX40 IP Telephony
Install IP Telephones
Install the IP Telephones and cables with the same care and considerations as any other device
connected to the local network. Before installing any telephone wiring, read the following caution
notes:
Power Adapter Connection
The IP Telephone (IPT) sets require external power. The power supply can be from the AC adapter
included with the IPT or the LAN using a Power Over Ethernet (POE). POE must meet
IEEE802.3af standard. Toshiba recommends the SMC6824MPE PoE switch. Refer to “Power over
LAN” in the CIX and MAS Installation and Maintenance Manual.
The IPT 2000 series station power adapter have a 90 degree plug. This adapter plugs into the
bottom of the IPT set. The right angle plug does not interfere with the tilt base or wall mounting.
For desk top installation use the strain relief tab at the top of the set for the AC adapter cable.
DSS, ADM and External Speaker Control Box (BESCB)
The IPTs can each support two ADMs or three DSS modules. The station can support DSS or
ADM but not a DSS and ADM. It is necessary to remove the tilt base from the IPT and ADM or
DSS to Attach the brackets and cables. Refer to the CIX and MAS Installation and Maintenance
Manual. Refer to the CIX and MAS Installation and Maintenance Manual for DSS, ADM and
External Stpeaker Control Box installation.
To Next Page
Loading...
