CIX40 IP Telephony
Install the GIPH1
2-2 Strata CIX40 Installation and Maintenance 7/06
Install the GIPH1
GIPH1 Installation
1. Ensure that the GIPH1 is installed in the cabinet and that the card stopper is secured
(see Figure 1-13).
2. Power up the system.
3. Program the CIX per the instructions in the Strata CIX Programming Manual Vol. 1,
refer to the chapter titled “IP Telephone Programming” and “Appendix A – “Application
Guide.”
Note When the GIPH1 is configured for G.729a codec use and the echo cancel delay is
set to 32 ms the card will operate as follows:
• Six resources will function as G.729a with 32 ms echo cancel delay.
• Two resources will function as G.729a with 16 ms echo cancel delay.
When the echo cancel delay is set to 16 ms or the codec is G.711 this does not apply,
all channels are available.
Connect GIPH1 to LAN or VPN Server
1. Plug one end of a straight-through CAT5/5E/6 LAN cable into the RJ45 Ethernet port
on the GIPH1 in the CIX. (See Figure 1-16.)
2. Plug the other end of the LAN cable into a LAN or server jack refer to Figure 2-1. The
GIPH1 cable is a straight-through cable.
Figure 2-1 IP LAN Connections
CIX40
GCTU2
GIPH1
Network Switch
MAS*
IPT
LAN
*Optional
IPT
IPT
Router
WAN
CIX
LIPU
or
GIPH1
or
BIPU-Q
Strat Net IP
To Next Page
Loading...
