4.2 Wireless LAN Card 4 Replacement Procedures
Figure 4-11 Removing the wireless LAN card
Installing the Wireless LAN Card
Install the wireless LAN card according to the following procedures and Figures 4-10, 4-11.
1. Insert the wireless LAN card into the connector at angle of 45 degrees.
2. Tilt the wireless LAN card and fix it with the left and right stoppers.
3. Connect the two antenna cables with the tweezers.
4. Install the wireless LAN cover.
5. Securing the wireless LAN cover by LAN cover securing screw.
CAUTION: Do not touch the connectors on the wireless LAN card and in the computer
with bare hands. Wireless LAN cards can fail if they are contaminated with sweat, natural
oils, etc. from your hands.
Satellite M40/M45, TECRA A4, dynabook Vx/4
Maintenance Manual 4-23
To Next Page
Loading...
