4.18 Switch Cover and Switch board 4 Replacement Procedures
Figure 4-43 Removing the switch Board
Install the Switch Cover and Switch Board
Install the switch board according to the following procedures and Figure 4-42, 4-43.
1. Place the switch board on the correct position and securing it with the two M2.5x4
black flat-head screws.
2. Connect the switch board flat cables to CN3002 on the switch board.
3. Place the switch cover in the correct position and fasten the following 6 latches, in
that order:
-Three latches on each of the left and right sides
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-61
To Next Page
Loading...
