3.2 Quick Start 3 Diagnostic Programs
User can press any key to exit the program.
3.2.8 DMI Write
In addition to reading the DMI information, DMI Write also permits attributes editing
and updating: Manufacture, Product Name, Version, Serial Number, UUID and OEM
Part Number, etc. The following screen will be displayed:
In this screen, there are two lines which attribute could be edited and updated. The 1
st
line (the font in yellow with blue background) shows the attribute’s value that is read
from the current system and the 2
nd
line (the font in red with turquoise background)
shows the same value as that in the 1
st
line before user’s editing. User can modify the
attribute’s value in the 2
nd
line and press Enter to confirm the current edition and
continue editing the next attribute.
During the editing, user could press F2 to confirm the DMI attribute update or press F4
to ignore the modification. Press ESC to exit the program of DMI Write.
The confirmation screen is as below:
Satellite M40/M45 TECRA A4 Dynabook Vx/4 Maintenance
Manual 9
To Next Page
Loading...
