4 Replacement Procedures 4.9 Display Assembly
4.9 Display Assembly
Removing the Display Assembly
CAUTION: Use care to avoid that the antenna cable for antenna is caught between the
display assembly and computer.
Remove the display assembly according to the following procedures and Figures 4-27, 4-28.
1. Turn the computer back to front and remove four M2.5x8 black flat-head screws.
2. Restore the normal computer placement and open the display panel.
Figure 4-27 Removing the screws from the back of the compute
3. Disconnect the LCD/FL cable from CN1on the system board.
4. Remove two M2.5x5 black flat-head screws to secure the LCD module to top cover.
5. Remove the wireless antenna cables from the top cover.
6. Remove the display module.
4-40 Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual
To Next Page
Loading...
