4.18 Touch Pad and Button Board 4 Replacement Procedures
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-63
Installing the Touch Pad Board and Button Board
Install the Touch Pad Board and Button Board according to the following procedures and
Figure 4-44.
1. Connect the touch pad flat cables to CN3000 and button board flat cable to CN3001
on the button board.
2. Place the button board on the correct position and securing it with the two M2.5x3
flat-round-head screws.
3. Place the touch pad on the correct position and securing it with the two M2.5x4 black
flat-head screws.
4. Connect the touch pad flat cables to J1 on the touch pad.
To Next Page
Loading...
