4.8 ODD bay Module 4 Replacement Procedures
Disassembling the ODD Drive
NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it failed.
Disassemble the ODD drive according to the following procedures and Figures 4-26.
1. Remove the two M2x3 white flat-head screws.
2. Remove the bracket.
Figure 4-26 Removing the bracket from the ODD drive
Assembling the ODD Drive
Assemble the ODD drive according to the following procedures and Figures 4-26.
1. Secure the bracket with the two M2x3 white flat-head screws.
Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual 4-39
To Next Page
Loading...
