4 Replacement Procedures 4.14 Display Mask
4.14 Display Mask
Removing the Display Mask
Remove the display mask according to the following procedures and Figure 4-36.
1. Remove the following 4 seals on the display module in that order:
- Two black seals on the bottom
- Two black seals on the top
2. Remove the following 4 screw on the display module, in that order:
- Two M2.5x4.5 white flat-head screws on the top
- Two M2.5x4.5 white flat-head screws on bottom
3. Release the following 25 latches on the display mask, in that order:
- Six bottom latches
- Five latches on each of the left and right sides
- Nine top latches
Figure 4-36 Removing the display mask
4-52 Satellite M40/M45, TECRA A4, dynabook Vx/4 Maintenance Manual
To Next Page
Loading...
