4.3 HDD 4 Replacement Procedures
Figure 4-13 Removing the HDD pack
4. Remove the HDD pack by pulling the HDD tap attached to the HDD pack.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble or
replace the HDD pack only if it failed.
5. Place the HDD pack on a flat surface (such as a desk), and remove the two M3x4
black flat-head screws with M3x4 white head screws.
6. Remove the HDD chassis.
7. Remove the HDD connector.
Figure 4-14 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.
Satellite M40/M45, TECRA A4, dynabook Vx/4
Maintenance Manual 4-25
To Next Page
Loading...
