4.12 Cover assembly and Base assembly 4 Replacement Procedures
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813) [CONFIDENTIAL] 4-43
4. Turn over the computer and open the display.
5. Turn up the insulator (LCD CONN INSULATOR) and disconnect the LCD harness
from the connector CN5300 on the system board.
6. Disconnect the FS board FFC and camera harness from the connector CN9550 and
CN9540 on the system board.
Figure 4-24 Removing the cover assembly and base assembly (3)
FS board FFC
(Connected to CN9550)
LCD harness
(Connected to CN5300)
Camera harness
(Connected to CN9540)
Insulator
(LCD CONN INSULATOR)
To Next Page
Loading...
