– 41 –
STE 71282
STARTUP MANUAL
The robot executes to the end command of the program and stops.
[5] Press the NEXT key to assign [CONT] to the [F1] key of the function menu.
Press the [F1] key then.
Press the EXE key to select the continuous operation.
Before starting the operation, confirm the selected program name, operation
mode and override set value.
Press the NEXT key to assign [RUN] to the [F4] key of the function menu.
Press the [F4] key then.
Press the EXE key, and the continuous operation starts.
The robot repeats the program from the top to the end command.
[6] Stop of program execution.
Press the NEXT key to assign [STOP] to the [F4] key of the function menu.
Press the [F4] key then.
The robot stops executing the program after the current command has been
executed.
You can stop the program also by pressing the STOP key provided on the
control panel.
To execute the program again, select [RUN] from the function menu.
R E SET
M O D E :C O N T
C O N T C Y C L E S E G S T E P
R E SET
R U N
E D I T D E D I T S E L R U N F I L E >
R E SET
M O D E O V R D B R E A K S T O P W A T C H >
To Next Page
Loading...
