Toshiba V Series - Network Components

40
model 3000 DeviceNet Module Manual (DN311/DN311A)
Chapter 3 Preparations for Operation (Hardware)
3
3.6 Network Components
This section explains the network components of the DeviceNet other than the master/
slave devices (Figure 3-16). Recommended peripheral devices are introduced on the
following pages for you to purchase as necessary. For detailed information on them, ask
their manufacturers.
Figure 3-16 Example of DeviceNet Network Configuration
(1) Thick Cable (for trunk line)
Manufacturer: Rockwell Automation
(2) Thin Cable (for trunk line and drop line)
Manufacturer: Rockwell Automation
Item name Catalog No. Remarks
1 m with connectors 1485C-P1N5-M5 1485C-P1N5-M5 Shielded mini-connectors
(male, female) attached
Shielded mini-connector (male) at one end,
shielded mini-connector (female) at the other
end
2 m with connectors 1485C-P2N5-M5
3 m with connectors 1485C-P3N5-M5
5 m with connectors 1485C-P5N5-M5
10 m with connectors 1485C-P10N5-M5
50 m without connector 1485C-P1-A50 Shielded mini-connectors, 871A-TS5-NM3
(male) and 871A-Ts5-N3 (female) to be
attached later
150 m without connector 1485C-P1-A150
300 m without connector 1485C-P1-A300
Item name Catalog No. Remarks
1 m with connectors 1485R-P1M5-C Shielded mini-connector (male) at one end
and a discrete end at the other for open-type
connector
2 m with connectors 1485R-P2M5-C
3 m with connectors 1485R-P3M5-C
150 m without connector 1485C-P1-C150 Used for daisy-chain connection from one
open-type connector to another. Used for
connecting DeviceBox Tap to an open-type
connector
300 m without connector 1485C-P1-C300
600 m without connector 1485C-P1-C600
Node
Node
Node
Node
Node
Node
Node
Node
Node
Node Node
Node
Node
Tap
Tap
Multiport tap
Terminator
Tap
Multiport tap
Drop line
Trunk line
Terminator