tousek PULL T24 - Page 12

- 12 - tousek / E_PULL-T24-T24speed_49002410 / 06. 08. 2019
Main layer Sub layer Settings/adjustments
button/switches

page 13
impulse button
 OPEN/STOP/CLOSE
 OPEN/CLOSE/OPEN
 OPEN
 DEAD MAN
*) if impulse button is
set to DEADMAN, then
the pedestrian and
close button are also
set automatically to
DEADMAN mode.
(not selectable under
„pedest.- button“)
)
pedestrian button
 OPEN/STOP/CLOSE
 OPEN/CLOSE/OPEN
 OPEN
 Impulse OPEN
 DEAD MAN
*)
safety

page 15
G
photocell
 active
 not active
G
main safety edge
 active
 radio edge TX
 TX 400
 not active
G
side safety edge
 active
 radio edge TX
 TX 400
 not active
photoc.-function
 when closing reverse
 stop - after release open
 during close stop, then close
PHC-pause time
 no inuence of photocell
 abort of pause time
 re-start of pause time
 immediate close after opening
PHC-self test
 active
 not active
motor

page 19
max. force
 50...100% [increment 5 ]  = 100%
ARS-response time
 0,15...0,95s [increment 0,05]  = 0,50s
speed
 55...100% [increment 5]  = 100%
soft stop way
 0...2m [increment 0,1]  = 0,5m
soft speed
 10...50% [increment 5]  = 40%
limit position OPEN
 0...-30 [increment 1]  = -5
limit position CLOSE
 0...-30 [increment 1]  = -5
operating mode

page 20
impulse mode
 stop, start of pause time
 impulse suppression when opening
 pause time extension
G
opening direction
 <<<
–
left

–
>>> right
G
operating mode
 impulse mode
 aut. close 1...255s [increment 1]
partial opening
 10...100% [increment 1]  = 30%
automatic mode
 complete/partial opening
 only complete opening
 only partial opening
pause time logic
 no inuence
 always open in automatic mode
lights/lamps

page 21
prewarning OPEN
 OFF, 1...30s  = OFF
prewarning CLOSE
 OFF, 1...30s  = OFF
additional module
 yard/control light
 status display 1
 status display 2
courtyard light
1)
 OFF, 5...950s  = OFF
control lamp
1)
 illuminates when opening/closing
 blinks slowly / illuminates / blinks
 illuminates in open position
diagnosis

page 23
status display
 status display of all inputs
delete position
 NO
 YES
factory setting
 NO
 YES
software version
 show software version
serial number
 show serial number
protocol
 show protocol notes
status sensor
 show sensor
1)
The menu points courtyard lamp and control lamp will only appear on display if in menu
„Additional module"  courtyard lamp/control lamp is selected.
Menu structure Adjustments - overview
+
–
integr. control board for sliders PULL T24, -T24speed
ESC
ENTER
Note: some adjustments regarding function or operating logic can only be executed if gate is closed and if the display shows „ready“.