OPERATING TIPS
POINTS FOR
WHICH
SPECIAL CARE MUST
BE
TAKEN
1. Always set the engine on an engine stand for carrying out assembly and disassembly of an engine. Never
operate on a workbench or on the floor as this is dangerous.
2.
When handling and moving the cylinder head ASSY or the cylinder block, always wear gloves and do not use
your bare hands.
GENERAL INSTRUCTIONS
1. For safe operation
(1) Wear the correct safety gear (cap, safety goggles, gloves, safety shoes).
(2) To prevent burns, do not touch the radiator, muffler or exhaust pipe directly after stopping the engine.
(3) Do not put your clothing or tools near to the rotating part when the engine is turning.
(4)
When the engine is not on, always have the engine switch
OFF,
and remove the starter key.
2. Preparation for disassembly
(1) Prepare general tools,
SSTs, measuring instruments, lubricant and parts that cannot be reused.
(2) When disassembling a complex part, put imprints and match marks in places that will not effect the function
of the part in order to facilitate easy reassembly.
3.
Prevention of entry of foreign bodies
Foreign bodies such as dust, sand and metal pieces inside the engine cause faults to occur.
(1) Thoroughly remove sand and mud etc. sticking to the engine exterior.
(2) Protect disassembled parts from dust with a plastic cover or similar.
To Next Page
Loading...
Need help?
General
