User Guide 26
Switching Configuring Ports
Flow Control Select On or Off to enable or disable the Flow Control feature. When Flow Control
is enabled, when the switch gets overloaded, it will send a PAUSE frame to notify
the peer device to stop sending data for a specific period of time, thus avoiding
the packet loss caused by congestion.
2) Click Apply.
Note:
•
It is recommended to set the ports on both ends of a link with the same speed and duplex
mode.
•
Keep the port that is connected to the management device enabled, or you cannot access the
switch.
•
The parameters of the port members in a LAG should be set as the same.
To Next Page
Loading...
Need help?
General