TP-Link EAP115 - Page 109

101
 Wireless Settings
Figure 7-41 Wireless Settings
Channel/Frequency:
Displays the channel number and the operating frequency. If you want
to change them, please refer to 5.1.1 Wireless Basic Settings
.
Channel Width:
Displays the spectral width of the radio channel used by the device. If
you want to change it, refer to 5.1.1 Wireless Basic Settings
.
IEEE802.11 Mode:
Displays the radio standard used for operation of your device. If you
want to change it, refer to 5.1.1 Wireless Basic Settings.
Max TX Rate:
Displays the maximum data rate at which the device should transmit
wireless packets.
Transmit Power:
Displays the maximum average transmit power of the device. If you
want to change it, refer to 5.1.1 Wireless Basic Settings
.
 LAN Information
Figure 7-42 LAN Information
MAC Address:
Displays the MAC address of the device.
IP Address:
Displays the IP address of the device.
Subnet Mask:
Displays the subnet mask of the device.
LAN Port:
Displays the maximum transmission rate and duplex mode (half-duplex or
full-duplex) of the port.