TD-W8910G 54M Wireless ADSL2+ Router User Guide
20
Figure 5-3
¾ WAN Port Information Table: This table describes the WAN port settings and the relevant
manipulation to each interface.
¾ Remove: Select the check box in the table (shown in Figure 5-3) and then click the Remove
tab, the corresponding interface will be deleted in the table.
¾ Add: Click the Add button, you can add a new interface in the next screen (shown in Figure
5-4).
¾ Save/Reboot: If you are sure of the settings, choose Save/Reboot to apply the changes and
reboot the system.
)
Note:
You have to reboot to activate the WAN interface and further configuration services over this
interface. Click the Save/Reboot button to implement it.
Follow the instructions below to Add or Edit an ATM PVC
1. Click the Add button on the screen above (shown in Figure 5-3), then you will see the next
screen as follows (Figure 5-4):
To Next Page
Loading...
