10. Click Next to continue, the Wireless settings page will appear as shown in Figure 3-19.
Figure 3-19 Quick Setup – Wireless
Wireless Radio - Enable or disable the wireless function.
Wireless Network Name - Enter a string of up to 32 characters. The same name of
SSID (Service Set Identification) must be assigned to all wireless devices in your
network. Considering your wireless network security, the default SSID is set to be
TP-LINK_XXXX (XXXX indicates the last unique four numbers of each router’s MAC
address). This value is case-sensitive. For example, TEST is NOT the same as test.
Disable Security - The wireless security function can be enabled or disabled. If
disabled, the wireless stations will be able to connect the router without encryption. It
is recommended strongly that you choose one of following options to enable security.
WPA-PSK/WPA2-PSK – Select WPA-PSK/WPA2-PSK based on pre-shared
passphrase.
Wireless Password - You can enter ASCII or Hexadecimal characters.
For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z,
the length should be between 8 and 63 characters.
-18-
To Next Page
Loading...
