Note:
If your PC is blocked and you want to access the router again, press and hold down the
WPS/RESET button on the rear panel of the router until the Power LED starts flashing to reset
the router's factory defaults in the router's Web-Based Utility.
4.12.3 Remote Management
Choose menu “Security
Remote Management”, you can configure the Remote
Management function in the screen as shown in Figure 4-45. This feature allows you to manage
your Router from a remote location via the Internet.
Figure 4-45 Remote Management
Web Management Port - Web browser access normally uses the standard HTTP service
port 80. This Router's default remote management web port number is 80. For greater
security, you can change the remote management web port to a custom port by entering
that number in the box provided. Choose a number between 1 and 65535 but do not use
the number of any common service port.
Remote Management IP Address - This is the current address you will use when
accessing your Router from the Internet. This function is disabled when the IP address is
set to the default value of 0.0.0.0. To enable this function change 0.0.0.0 to a valid IP
address. If set to 255.255.255.255, then all the hosts can access the router from internet.
To access the router, you should enter your Router's WAN IP address into your browser's
address (in IE) or location (in Netscape) box, followed by a colon and the custom port number
you set in the Web Management Port box. For example, if your Router's WAN address is
202.96.12.8 and you use port number 8080, enter http://202.96.12.8:8080 in your browser. You
will be asked for the router's password. After successfully entering the password, you will be
able to access the router's web-based utility.
Note:
1) Some ports are commonly used for other services (Such as 21, 25, 110, 119, 139, 145
and 445). For security reasons, these ports will be restricted.
2) Be sure to change the router's default password to a secure password.
3) If the web management port conflicts with the one used for a Virtual Server entry, the
entry will be automatically disabled after the setting is saved.
-54-
To Next Page
Loading...
