Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
Figure 8-6 VLAN Config
The following entries are displayed on this screen:
VLAN Config
VLAN ID: Enter the VLAN ID to enable IGMP
Specify the aging time of the router port. Within this time, if the
t receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Member Port Time:
Specify the aging time of the member port. Within this time, if the
t receive IGMP report message from the member
port, it will consider this port is not a member port any more.
Leave Time:
Specify the interval between the switch receivin
g a leave message
from a host and the switch removing the host from the multicast
groups.
Static Router Ports: Enter
the static router port which is mainly used in the network
VLAN Table
VLAN ID Select: Click the Select button to quick-
select the corresponding VLAN ID
based on the ID number you entered.
Select: Select the desired VLAN ID for configuration. It is multi-optional.
VLAN ID: Displays the VLAN ID.
Router Port Time: Displays the router port time of the VLAN.
117
To Next Page
Loading...
