TP-Link TL-SG3210 - NTDP Config

14.2.3 NTDP Config
On this page you can configure NTDP globally.
Choose the menu Cluster→NTDP→NTDP Config to load the following page.
Figure 14-8 NTDP Config
The following entries are displayed on this screen:

Global Config
NTDP: Select Enable/Disable NTDP for the switch globally.
NTDP Interval Time:
Enter the interval to collect topology information. The default is 1
minute.
NTDP Hops:
Enter the hop count the switch topology collects. The default is 3
hops.
NTDP Hop Delay:
Enter the time between the switch receiving NTDP request
packets and the
switch forwarding NTDP request packets for the
first time. The default is 200 milliseconds.
NTDP Port Delay:
Enter the time between the port forwarding NTDP request packets
and its adjacent port forwarding NTDP request packets over. The
default is 20 milliseconds.

Port Config
228