TP-Link TL-SG3210 - Application Example for Protocol VLAN

 Configure Switch B
Step Operation Description
1
Configure the
Link Type of the
ports
Required. On VLAN→802.1Q VLAN →Port Config
page, configure
the link type of Port 21 and
Port 22 as GENERAL and TRUNK
respectively.
2
Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN
ID as 10, owning Port 21 and Port 22, and
configure the egress rule of Port 21 as Untag.
3
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN
ID as 20, owning Port 21 and Port 22, and
configure the egress rule of Port 21 as Untag.
4
Configure MAC
VLAN 10
On VLAN→MAC VLAN
page, create MAC VLAN10 with the MAC
address as 00-19-56-8A-4C-71.
5
Configure MAC
VLAN 20
On VLAN→MAC VLAN
page, create MAC VLAN10 with the MAC
address as 00-19-56-82-3B-70.
 Configure Switch C
Step Operation Description
1
Configure the
Link Type of the
ports
Required. On VLAN→802.1Q VLAN →Port Config
page, configure
the link type of Port 2 and Port 3 as GENERAL, and configure the link
type of Port 4 and Port 5 as ACCESS.
2
Create VLAN10 Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 10, owning Port 2, Port 3 and Port 5,
3
Create VLAN20 Required. On VLAN→802.1Q VLAN→VLAN Config page, create a
VLAN with its VLAN ID as 20, owning Port 2, Port 3 and Port 4,
6.6 Application Example for Protocol VLAN
 Network Requirements
 Department A is connected to the company LAN via Port12 of switch A;
 Department A has IP host and AppleTalk host;
 IP host, in VLAN10, is served by IP server while AppleTalk host is served by AppleTalk server;
 Switch B is connected to IP server and AppleTalk server.
82