Chapter Introduction
Chapter 14 Cluster This module is used to configure cluster function to central manage
the scattered devices in the network. Here mainly introduces:
NDP: Configure NDP function to get the information of the directly
connected neighbor devices.
NTDP: Configure NTDP function for the commander switch to
collect NDP information.
Cluster: Configure cluster function to establish and maintain
This module is used to configure LLDP function to provide
information for SNMP applications to simplify troubleshooting. Here
mainly introduces:
Basic Config: Configure the LLDP parameters of the device.
Device Info: View the LLDP information of the local device and its
neighbors.
Device Statistics: View the LLDP statistics of the local device.
LLDP-MED: Configure LLDP-MED parameters of the device.
Chapter 16 Maintenance This module is used to assemble the commonly used system tools
to manage the switch. Here mainly introduces:
System Monitor: Monitor the memory and CPU of the switch.
Log: View configuration parameters on the switch.
Device Diagnostics:
Test the connection status of the cable
, test if the port of the switch and the
connected device are available.
Network Diagnostics
: Test if the destination is reachable and the
account of router hops from the switch to the destination.
Appendix A Specifications Lists the hardware specifications of the switch.
Appendix B Configure the PCs Introduces how to configure the PCs.
Appendix C Load Software
Using FTP
Introduces how to load firmware of the switch via FTP function.
Appendix D 802.1X Client
Software
Introduces how to use 802.1X Client Software provided for
authentication.
Appendix E Glossary Lists the glossary used in this manual.
Return to CONTENTS
5
To Next Page
Loading...
