TP-Link TL-SG3210 - 15.3 Device Statistics

 Network Diagram
Figure 14-15 Network diagram
 Configuration Procedure
 Configure the member switch
Step Operation Description
1
Enable NDP function on the
switch and for port 1
On Cluster→NDP→NDP Config
page, enable NDP
function.
2
Enable NTDP function on the
switch and for port 1
On Cluster→NTDP→NTDP Config
page, enable
NTDP function.
 Configure the commander switch
Step Operation Description
1
Enable NDP function on the
switch and for port 1, port 2 and
port 3
On Cluster→NDP→NDP Config
page, enable NDP
function.
2
Enable NTDP function on the
switch and for port 1, port 2 and
port 3
On Cluster→NTDP→NTDP Config
page, enable
NTDP function.
3
Create a cluster and configure
the related parameters
On Cluster→Cluster→Cluster Config page, configure
the role as Commander and enter the related
information.
IP pool: 175.128.0.1
Mask: 255.255.255.0
233