TP-Link TL-SG3210

To Next Page

To Previous Page

Figure D-5 Install the Program

6) The InstallShield Wizard is installing TpSupplicant shown as the following screen. Please

wait.

Figure D-6 Setup Status

7) On the following screen, click Finish to complete the installation.

273

Main Page

Default Chapter2
- Ce Mark Warning2
- Fcc Statement2
- Safety Information3
- Table of Contents4
- Package Contents11
Chapter 1 About this Guide12
- Intended Readers12
- Conventions12
- Overview of this Guide12
Chapter 2 Introduction16
- Overview of the Switch16
- Main Features16
- Appearance Description17
  - Front Panel17
  - Rear Panel19
Chapter 3 Login to the Switch21
- Login21
- Configuration21
Chapter 4 System23
- System Info23
- User Management38
  - User Table38
  - User Config38
- System Tools40
- Access Security42
Chapter 5 Switching52
- Port52
- Lag60
- Traffic Monitor65
  - Traffic Summary65
  - Traffic Statistics67
- MAC Address68
Chapter 6 VLAN76
- Q Vlan77
- Mac Vlan83
- Protocol VLAN84
- Application Example for 802.1Q VLAN89
- Application Example for MAC VLAN91
- Application Example for Protocol VLAN92
- Gvrp94
Chapter 7 Spanning Tree98
- STP Config103
  - STP Summary105
- Port Config106
- MSTP Instance108
- STP Security113
  - Port Protect113
  - TC Protect115
- Application Example for STP Function115
Chapter 8 Multicast120
- IGMP Snooping124
- MLD Snooping136
- Multicast Table146
  - Ipv4 Multicast Table146
  - Ipv6 Multicast Table147
Chapter 9 Qos148
- Diffserv151
- Bandwidth Control155
  - Rate Limit155
  - Storm Control156
- Voice VLAN158
Chapter 10 Poe164
- Poe Config164
  - Poe Config165
  - Poe Profile166
- Poe Time-Range167
Chapter 11 ACL171
- Time-Range171
- ACL Config173
- Policy Config178
- Policy Binding180
- Application Example for ACL182
Chapter 12 Network Security185
- IP-MAC Binding185
- ARP Inspection195
- Dos Defend202
- 194204
Chapter 13 SNMP214
- SNMP Config216
- Notification223
- Rmon225
Chapter 14 Cluster230
- Ndp231
- Ntdp235
- Cluster239
  - Cluster Summary239
  - Cluster Config240
- Application Example for Cluster Function242
Chapter 15 LLDP245
- Basic Config249
  - Global Config249
  - Port Config250
- Device Info251
  - Local Info251
  - Neighbor Info252
- Device Statistics252
- Lldp-Med254
Chapter 16 Maintenance260
- System Monitor260
  - CPU Monitor260
  - Memory Monitor261
- Log261
- Device Diagnostics266
  - Cable Test266
- Network Diagnostics267
  - Ping267
  - Tracert268
Appendix A: Specifications269
Appendix B: Configuring the Pcs271
Appendix C: Load Software Using FTP276
Appendix D: 802.1X Client Software281
Appendix E: Glossary289

TP-Link TL-SG3210 - Page 283

Table of Contents

Other manuals for TP-Link TL-SG3210

Related product manuals