116
2 ) Click
Save.
Note: Log in to the web management page again if the IP address of the router has been altered.
3. Survey the SSID to be bridged:
1 ) Go to
Wireless > Wireless Settings and click Enable WDS Bridging.
2 ) Click Survey, locate the host router’s SSID and click Choose (here we take
TP-Link_2512 for example).
3 ) If the host router is set with a wireless password, you should enter its wireless
password.
4 ) Click
Save.
4. Disable DHCP: Go to DHCP, select Disable, and click Save.
Now you can go to
Status to check the WDS status. When the WDS status is Run, it
means WDS bridging is successfully built.
To Next Page
Loading...
