T+A MP 200 User Manual

Conguration using the WPS function
• First activate the WPS-function of the Router or Repeater to which you wish the MP 200 to be connec-
ted. For details please refer the manual of the device in question.
• Start the WPS-Autoconnect function of the MP 200 within 2 minutes.
• Use the buttons to select the menu point “WPS-Autoconnect”, then conrm your choice
with the button.
• After the connection is established, the line Status shows the connected WLAN network.
• Finally select the “Store and exit?” menu point and press the button to accept the settings.
Manual setup of the WLAN connection
• First select the Scan for WLAN menu item and conrm it with the button.
• A list of the WLANs found appears.
• Use the buttons to select the WLAN to which you wish the MP 200 to be connected, and conrm
your choice with the button.
• Enter the network password (passphrase) and conrm your entry with .
• Conrm and store the settings by selecting the item Store and exit? and pressing .
• Finally, select the menu item Store and exit? again and conrm the settings with the button again.
Setting up the WLAN connection via the T+A app (TA Music Navigator)
The MP 200 supports setting up the WLAN connection via an access point. This means that the MP 200
provides its own WLAN for the duration of the conguration of the WLAN settings. As soon as the congu-
ration is complete, this WLAN is deactivated again. The MP 200 restarts and connects to the WLAN con-
gured via the app.
• Turn on the MP 200 and open the system conguration menu by pressing the button on the remote
control or the SYS button on the front of the MP 200.
• Use the buttons to select the menu point Network, then conrm your choice with the button.
• Use the buttons to select the menu point Access Point, then conrm your choice with the but-
ton.
• The MP 200 activates the WLAN access point.
• The following steps must be performed within approximately 5 minutes. After this time, the MP 200 will
exit access point mode automatically.
• Connect the smartphone or Tablet PC on which the T+A-app is installed to the WLAN access point. The
network name (SSID) is „T+A AP MP 200“ and the passphrase is “01234567”.
• Start the T+A-app for operation.
• The app recognizes the access point and starts automatically with the setup wizard.
• To set up the WLAN, go through the individual steps of the app‘s setup wizard.
• Quit the app, then connect your phone or tablet to your previously set up wireless LAN.
• After restarting the app the MP 200 will be detected automatically.
• Once the MP 200 is detected, it can be selected for playback.
33

T+A MP 200 Specifications

General

Brand	T+A
Model	MP 200
Category	Stereo System
Language	English